RRP: $3620
Monthly Promo: $2985
Key Advantages
- Equal cold and hot pressure
- Even mixing between cold and hot water
- Allows for those amazing and powerful showers. No more dancing around trying to stay warm!
- Increases your hot water pressure from 75Kpa to 500Kpa!
- Reduced hot water pressure drop when using more than one fixture at a time
- Removal and disposal of existing hot water cylinder
Included in the offer:
- Rheem 180L mains pressure hot water cylinder
- New mains pressure valve pack
- New cylinder tray (when possible)
- New seismic restraints to make sure the cylinder is nice and secure
- New copper pipework where required
- New electrical switch and connection
Terms and conditions:
- Where a house is built on a concrete slab and there is not an existing drain in the hot water cupboard, a mains pressure install may not be possible without cutting up the existing concrete slab. In this case, we would recommend alternative options like a gas califont or an outdoor hot water cylinder
- No allowances for sub trades apart from the electrician (replacing the existing switch and wiring)
- No building work has been allowed
- Where a house does not have a pressure limiting valve installed on the property, we can install this at an additional cost of $180+GST
- No allowance for the upgrading of existing low pressure tapware (this is not always required)
- Our electrical contractor will attend the site and connect the hot water cylinder. Please note, within this section, we have allowed for a standard wiring reconnection. If the onsite electrician deems the electrical components to be non-compliant, meaning the electrical box needs to be replaced or new wiring has to be run back to the distribution board, additional charges will apply
- Replacing or servicing of any tapware if required due to mixers not being suitable for mains pressure
- Rectification of any non-compliant existing installs or pipework
